Copperhead-NG Series Beretta Tomcat 3032 or Bobcat 21a High Quality Hex Head Natural Stainless Steel Grip Screw Set. This grip screw set is made of Stainless steel in its natural state which includes the four (4) screws. This set is for the proper screw currently installed on Beretta Tomcat/Bobcat models. This set is the proper size for all wood as these grips are made with the same recess size screw hole.
All Netticks Copperhead-NG screws are full thread design, this allows all threads equal holding strength. Some manufacturers choose to taper the end of the screw for easier alignment, while this does allow a more forgiving and simpler start of the screw it also reduces the amount of threads that actually hold the grips securely to the firearm. We do NOT recommend any thread locking agents be applied to these screws, as it is not necessary and can result in screw breakage during removal. The best way to start threading a full thread (Non-tapered) screw is to lightly turn the screw backwards until the first thread drops into the hole at a level consistent with the grip. Begin tightening with very light pressure and higher force should not be necessary, once you have several turns into the frame you can confidently tighten the screw. Be sure to have all screws started before you begin to tighten each screw fully.
A replacement set for new and older model pistols with original grips and/or replacement grips made by HRV Grips®
Made to fit all Beretta Tomcat 3032 and Bobcat 21a grips that use the original grip screws for installation.
Copperhead-NG Series Beretta Tomcat 3032 or Bobcat 21a High Quality Hex Head Natural Stainless Steel Grip Screw Set. This grip screw set is made of Stainless steel in its natural state which includes the four (4) screws. This set is for the proper screw currently installed on Beretta Tomcat/Bobcat models. This set is the proper size for all wood as these grips are made with the same recess size screw hole.
All Netticks Copperhead-NG screws are full thread design, this allows all threads equal holding strength. Some manufacturers choose to taper the end of the screw for easier alignment, while this does allow a more forgiving and simpler start of the screw it also reduces the amount of threads that actually hold the grips securely to the firearm. We do NOT recommend any thread locking agents be applied to these screws, as it is not necessary and can result in screw breakage during removal. The best way to start threading a full thread (Non-tapered) screw is to lightly turn the screw backwards until the first thread drops into the hole at a level consistent with the grip. Begin tightening with very light pressure and higher force should not be necessary, once you have several turns into the frame you can confidently tighten the screw. Be sure to have all screws started before you begin to tighten each screw fully.
A replacement set for new and older model pistols with original grips and/or replacement grips made by HRV Grips®
Made to fit all Beretta Tomcat 3032 and Bobcat 21a grips that use the original grip screws for installation.