Copperhead-NG Series Ruger Mark I - IV Hex Head Polished Stainless Steel Grip Screw Set. This grip screw set is made of Stainless steel in Natural polished and includes the four (4) screws. This set is for all Ruger Mark I to Mark IV, we are not aware of the screw size on the Lite models.
All Netticks Copperhead-NG screws are full thread design, this allows all threads equal holding strength. Some manufacturers choose to taper the end of the screw for easier alignment, while this does allow a more forgiving and simpler start of the screw it also reduces the amount of threads that actually hold the grips securely to the firearm. We do NOT recommend any thread locking agents be applied to these screws, as it is not necessary and can result in screw breakage during removal. The best way to start threading a full thread (Non-tapered) screw is to lightly turn the screw backwards until the first thread drops into the hole at a level consistent with the grip. Begin tightening with very light pressure and higher force should not be necessary, once you have several turns into the frame you can confidently tighten the screw. Be sure to have all screws started before you begin to tighten each screw fully.
Made to fit all Ruger Mark I to Mark IV grips on the original models. We are not sure if the Lite series uses the same screw.
Copperhead-NG Series Ruger Mark I - IV Hex Head Polished Stainless Steel Grip Screw Set. This grip screw set is made of Stainless steel in Natural polished and includes the four (4) screws. This set is for all Ruger Mark I to Mark IV, we are not aware of the screw size on the Lite models.
All Netticks Copperhead-NG screws are full thread design, this allows all threads equal holding strength. Some manufacturers choose to taper the end of the screw for easier alignment, while this does allow a more forgiving and simpler start of the screw it also reduces the amount of threads that actually hold the grips securely to the firearm. We do NOT recommend any thread locking agents be applied to these screws, as it is not necessary and can result in screw breakage during removal. The best way to start threading a full thread (Non-tapered) screw is to lightly turn the screw backwards until the first thread drops into the hole at a level consistent with the grip. Begin tightening with very light pressure and higher force should not be necessary, once you have several turns into the frame you can confidently tighten the screw. Be sure to have all screws started before you begin to tighten each screw fully.
Made to fit all Ruger Mark I to Mark IV grips on the original models. We are not sure if the Lite series uses the same screw.
After a successful surgical procedure on December 2, we expect a temporary shutdown of production for about one week.
In-house orders will be completed in the order received. We’ll be working extra hours and days to catch up and be back on schedule very soon after reopening.
Holiday orders may take longer due to seasonal demand. If your order is a Christmas gift, please let us know and we’ll do our best to accommodate you.
As a thank-you, our 100/200/300 Holiday Sale runs Dec 4–31, with automatic savings of 10% / 15% / 20% at checkout.
Our 100/200/300 Holiday Sale is usually held December 17–24. This year we’re saying thanks for your patience during our brief shutdown by extending the sale to December 4–31, 2025.
Discount is automatically applied at checkout. Holiday gift orders are welcome—tell us in the notes and we’ll do our best to accommodate.
Based on total order value — it may be worth adding an accessory or two to reach the next tier of savings.
