Copperhead-NG Series Browning UFX Buckmark Hex Head Black Stainless Steel Grip Screw Set. This grip screw set is made of Stainless steel in traditional Black which includes the two (2) screws and the Hex wrench to install. This set is for the new size screw currently installed on new UFX Buckmark models. This set is the proper size for new Netticks grips as these grips are made with the new recess size screw hole. The hex wrench includes a ball end to allow use at angles.
All Netticks Copperhead-NG screws are full thread design, this allows all threads equal holding strength. Some manufacturers choose to taper the end of the screw for easier alignment, while this does allow a more forgiving and simpler start of the screw it also reduces the amount of threads that actually hold the grips securely to the firearm. We do NOT recommend any thread locking agents be applied to these screws, as it is not necessary and can result in screw breakage during removal. The best way to start threading a full thread (Non-tapered) screw is to lightly turn the screw backwards until the first thread drops into the hole at a level consistent with the grip. Begin tightening with very light pressure and higher force should not be necessary, once you have several turns into the frame you can confidently tighten the screw. Be sure to have all screws started before you begin to tighten each screw fully.
A replacement set for older model grips with the original grip hole recess will be available at some point for older replacement options, and for new grips that are currently not offering the new recessed hole size.
Made to fit all UFX Buckmark grips with the wider new style grip hole recess.
Copperhead-NG Series Browning UFX Buckmark Hex Head Black Stainless Steel Grip Screw Set. This grip screw set is made of Stainless steel in traditional Black which includes the two (2) screws and the Hex wrench to install. This set is for the new size screw currently installed on new UFX Buckmark models. This set is the proper size for new Netticks grips as these grips are made with the new recess size screw hole. The hex wrench includes a ball end to allow use at angles.
All Netticks Copperhead-NG screws are full thread design, this allows all threads equal holding strength. Some manufacturers choose to taper the end of the screw for easier alignment, while this does allow a more forgiving and simpler start of the screw it also reduces the amount of threads that actually hold the grips securely to the firearm. We do NOT recommend any thread locking agents be applied to these screws, as it is not necessary and can result in screw breakage during removal. The best way to start threading a full thread (Non-tapered) screw is to lightly turn the screw backwards until the first thread drops into the hole at a level consistent with the grip. Begin tightening with very light pressure and higher force should not be necessary, once you have several turns into the frame you can confidently tighten the screw. Be sure to have all screws started before you begin to tighten each screw fully.
A replacement set for older model grips with the original grip hole recess will be available at some point for older replacement options, and for new grips that are currently not offering the new recessed hole size.
Made to fit all UFX Buckmark grips with the wider new style grip hole recess.