Copperhead-NG Series Browning UFX Buckmark Hex Head Original size (Small head) Stainless Steel Grip Screw Set. This grip screw set is made of Stainless steel in Natural polished which includes the two (2) screws. This set is for the OLD size screw installed on older UFX/UDX Buckmark models. This set will also allow using older grip panels on the newer UFX series buckmark models, as thread size is the same.
All Netticks Copperhead-NG screws are full thread design, this allows all threads equal holding strength. Some manufacturers choose to taper the end of the screw for easier alignment, while this does allow a more forgiving and simpler start of the screw it also reduces the amount of threads that actually hold the grips securely to the firearm. We do NOT recommend any thread locking agents be applied to these screws, as it is not necessary and can result in screw breakage during removal. The best way to start threading a full thread (Non-tapered) screw is to lightly turn the screw backwards until the first thread drops into the hole at a level consistent with the grip. Begin tightening with very light pressure and higher force should not be necessary, once you have several turns into the frame you can confidently tighten the screw. Be sure to have all screws started before you begin to tighten each screw fully.
Please see our other listing for the new larger size Browning Buckmark screws in black for new models, or new model grips being installed on older models.
Made to fit all UFX/UDX Buckmark grips with the original smaller style grip hole recess.
Copperhead-NG Series Browning UFX Buckmark Hex Head Original size (Small head) Stainless Steel Grip Screw Set. This grip screw set is made of Stainless steel in Natural polished which includes the two (2) screws. This set is for the OLD size screw installed on older UFX/UDX Buckmark models. This set will also allow using older grip panels on the newer UFX series buckmark models, as thread size is the same.
All Netticks Copperhead-NG screws are full thread design, this allows all threads equal holding strength. Some manufacturers choose to taper the end of the screw for easier alignment, while this does allow a more forgiving and simpler start of the screw it also reduces the amount of threads that actually hold the grips securely to the firearm. We do NOT recommend any thread locking agents be applied to these screws, as it is not necessary and can result in screw breakage during removal. The best way to start threading a full thread (Non-tapered) screw is to lightly turn the screw backwards until the first thread drops into the hole at a level consistent with the grip. Begin tightening with very light pressure and higher force should not be necessary, once you have several turns into the frame you can confidently tighten the screw. Be sure to have all screws started before you begin to tighten each screw fully.
Please see our other listing for the new larger size Browning Buckmark screws in black for new models, or new model grips being installed on older models.
Made to fit all UFX/UDX Buckmark grips with the original smaller style grip hole recess.
